; ;VAG-COM Measuring Block Labels ;ABA Engines: 2.0 L, 8 valve, OBD-1 ;ECU p/n 037-906-258-xx ;Bosch Motronic M 2.9 ;USA Golf-Jetta (8/92-12/95) ;USA Passat (8/94-12/95) ;USA Cabriolet (8/94-01/95) ; ;Based on: ;VAG-Com Default lables with additional data from ;John Grable-Car Comp with additional data from ;Robert Bently-Publication VD95. with additional data from ;Robert Bently-CD: Vw_b4 ; 0,0,Click for details-Data at idle-engine warm-coolant >=80°C : [Observed] [Corresponds ] : [Range ] [To ] 0,1,Engine Coolant Temp.,*****************,[181-224 ]=[80-110 C ] 0,2,Engine Load Signal,*******************,[26-44 ]=[1.3-2.2 ms. ] 0,3,Engine Speed,*************************,[80-88 ]=[800-880 rpm ] 0,4,O2S factor, Lambda********************,[92-164 ]=[0.7-1.3 Lambda ] 0,5,Learned Value for Idle Adaptation,****,[83-241 ]=[0.87-1.22 Lambda] 0,6,Undocumented,*************************,[May be adapt for part load ] note 1 0,7,Learned Value for Low Load Adaptation,,[92-164 ]=[0.7-1.3 Lambda ] note 2 0,8,Air Correction Value (Adaptation),****,[114-154 ]=[2.8-5.2 kgh. ] 0,9,Undocumented,*************************,[ ] 0,10,Ignition Timing,*********************,[76-93 ]=[2.25-15.0 BTDC ] ; ; note 1: If this applys then note 2 is correct ; note 2: On some ECU,s this may be adaption at full load ; 1,0,Engine Dynamic Data 1,1,Engine speed,,Idle spec.: 800-880 RPM 1,2,Coolent Temp,,Warm engine spec.:80-100 1,3,Lamda,,Spec.: 0.7-1.3 1,4,Ignition Angle,,Idle Spec.:2.25-15 ; 2,0,Engine Dynamic Data 2,1,Engine speed,,Idle spec.: 800-880 RPM 2,2,Injector, On Time,Idle spec.:2.8 - 5.2 ms. 2,3,V Batt,,Accepted range: 12.5-15 Volts 2,4,EGR Temp,,If EGR not present- reads constant 217°C - on Passats this is exhaust gas temp with a minimum value of 127.4° ; 3,0,Intake Conditions 3,1,Engine speed,,Idle spec.: 800-880 RPM 3,2,Engine Load,From MAF,This is a calculated value- 0-5% at idle 3,3,Throttle Angle,Degrees,Closed throttle 5-19° 3,4,Intake Air, Temp,Approx. ambiant temp Deg C°. ; 4,0,Mode 1, Drive 4,1,Engine Speed,,Idle spec.: 800-880 RPM 4,2,Engine Load, From MAF,This is a calculated value 4,3,Vehicle Speed,,Governed to approx 120 MPH 4,4,Mode Bits,See Lable File ;XXXXX Position Recognized or Function Enabled ;1 Acceleration Enrichment ; 1 Full Load ; 1 Part Load ; 1 Idle ; 1 Overrun (Deceleration Fuel Cut-Off) ; 5,0,Mode 2, Idle Control 5,1,Engine speed,,Idle spec.: 800-880 RPM 5,2,IAC Valve,Adaption,2.8 - 5.2 kg/h 5,3,IAC Valve,Duty Cycle,50 - 60% 5,4,Input Bits,See Label File ;XX_XX ;1 A.C. Compressor On ; 1 A.C.System On : - Vacant, Not Used ; 1 Automatic Trans Signal TCM To ECM ; 1 Manual Trans present or Auto Trans In Park or Neutral ; 6,0,Lamda Control 6,1,Lamda,Dynamic Data,0.7 -1.3 6,2,Lamda Adaption,Idle,0.87 - 1.22 6,3,Lamda Adaption,Part Load,If block 3 is always 1 than block 4 is part load adaption 6,4,Lamda Adaption,Full Load,0.7-1.3 ; ; ;EOR